Case Preparation

Thick necks can cause high chamber pressures and erratic shooting. Neck reamers remove excess neck material to ensure adequate clearance exists betwe

L.E. Wilson Case Trimmer and Mounting Stand with Case Holder Clamp (order case holders separately.) This mounting stand and clamping attachment make

This replacement Case Trimmer Cutter is designed to trim cases to length and has been perfected over the years to give you a flat square cut with lit

An improvement to a long standing superb case mouth chamfering tool with a newly designed handle that provides improved depth stop fingers and a much

K+M Case Mouth Tapered Reamer - An improvement to a long standing superb case mouth chamfering tool with a newly designed handle that provides improv

This special K+M Expander Mandrel is designed to expand a 6mm case necks up to .30 calibre in 1 stroke. It is recommended that a high lubricity lubri

These K+M replacement neck turner cutters are made out of heat treated tool steel that is ground to the correct dimensions. Replacement cutters for t

This is the replacement flash hole cutter for the K+M Professional Flash Hole Uniformer. This one is designed for standard cases with a .080" flash h

This is a replacement flash hole cutter for the K+M Professional Flash Hole Uniformer. This one is designed for "PPC" cases with the .062" flash hole

The K+M Flash Hole Uniformer over comes some of the most detrimental affects on accuracy. In cartridge manufacturing, the flash hole is "punched" int

The K+M Flash Hole Uniformer over comes some of the most detrimental affects on accuracy. In cartridge manufacturing, the flash hole is "punched" int

In cartridge manufacturing, the flash hole is "punched" into the brass. While this is the least expensive method, it has many shortcomings and incons

Small Pistol & Small Rifle set to 0.122" depth Designed with a drive shank to be used with your cordless screwdriver and/or either of K+M's handles.

Large Pistol set to .122" depth Designed with a drive shank to be used with your cordless screwdriver and/or either of K+M's handles. K+M's primer po

Large Rifle is set to 0.131" depth Designed with a drive shank to be used with your cordless screwdriver and/or either of K+M's handles. K+M's primer

The K+M Flash Hole Uniformer over comes some of the most detrimental affects on accuracy. In cartridge manufacturing, the flash hole is "punched" int

Improved ability to lock and unlock your case in the power adapter. Can be used with the K+M handle, cordless screw driver or drill. Slide the Power

This aluminum handle is used with the K+M Power Adapter if you prefer to utilise the power case driver in manual mode while neck turning. This handle

The Pilot Jack is used to assist setting the pilot position on the K+M Neck Turning Tool to achieve the proper cut into the case shoulder. Installati

This steel neck turning pilot is specifically for the K+M Neck Turning Tool. The use of a good lubricant is necessary to avoid galling brass during t

This steel neck turning pilot is specifically for the K+M Neck Turning Tool. The use of a good lubricant is necessary to avoid galling brass during t

This steel neck turning pilot is specifically for the K+M Neck Turning Tool. The use of a good lubricant is necessary to avoid galling brass during t

This steel neck turning pilot is specifically for the K+M Neck Turning Tool. The use of a good lubricant is necessary to avoid galling brass during t

This steel neck turning pilot is specifically for the K+M Neck Turning Tool. The use of a good lubricant is necessary to avoid galling brass during t